Symmetricom TimeProvider 5000 User Manual page 242

Chapter 3
TimeProvider 5000 CLI Command Set
To provision the state of SNMP v2 communities:

set snmp state-v2 {enable | disable}
To set the SNMP sys-obj MIB version to either 1.2 or 2.0:

set snmp sys-obj-mib {1.2 | 2.0}
To set the SNMP trap MIB version to either 1.2 or 2.0:

set snmp trap-mib {1.2 | 2.0}
Example 1:
To add SNMP user named "maynard", with a security level of
tp5000> set snmp add user maynard securelvl priv
Response 1:
For security level of
Authentication protocol (MD5 or SHA):
Authentication key [Only chars {a-z,A-Z,0-9,! ( )- _ . ? ~ * @ ^ +
= : / %} are accepted] :
Privacy protocol (DES or AES):
Privacy key [Only chars {a-z,A-Z,0-9,! ( )- _ . ? ~ * @ ^ + = : / %}
are accepted]:
If the security level is
authkey <authkey-value>
authtype {MD5 | SHA}
Example 2:
To add SNMP v2-community named "groupv2", with a security level of read-write:
tp5000> set snmp add v2-community groupv2 securelvl
read-write
Example 3:
To add SNMP manager with the IP address 192.168.5.177 and engine ID of
0x12345678901234:
set snmp add manager 192.168.5.177 engineid 0x12345678901234
Example 4:
To delete SNMP trap user named "george3":
242 TimeProvider 5000 User's Guide
, the TP5000 will prompt for:
priv
, the TP5000 will prompt for:
auth
:
"priv"
098-00028-000 Revision F – May, 2012