Two-Step Clock - Symmetricom TimeProvider 5000 User Manual

Chapter 4 Provisioning
Provisioning PTP
Table 4-13. PTP
Parameter
state
address
clock-id
vlanid
sync-int
announce-int
delay-int
Figure 4-16. Two-Step Clock
306 TimeProvider 5000 User's Guide

Unicast Static Addressing Mode Parameter Descriptions
Use to enable or disable Unicast - Static mode on the TP5000
on the specified port.
Sets the static IP address for a client for the specified port.
Use to enter the clock ID for the specified client.
Use to enter the VLAN ID to be used for the specified client on
the specified port. The VLAN must configured and enabled in
order to use this. (See
Sets the synchronization interval for the TP5000 Grandmaster,
how often to send synchronization messages (T1) to clients on
the specified port.
z
The interval is 2 seconds, where z= <sync-int-value>.
Sets the announce interval for the TP5000 Grandmaster, how
often to send announce messages to clients on specified port.
z
The interval is 2 seconds, where z= <announce-int-value>.
Sets the delay interval for the TP5000 Grandmaster, how often
to expect to receive delay request messages (T3 - T4) from
clients on the specified port.
z
The interval is 2 seconds, where z= <delay-limit-value>.
Description
Provisioning VLAN, on page 287)
098-00028-000 Revision F – May, 2012