Symmetricom TimeProvider 5000 User Manual page 216

Chapter 3
TimeProvider 5000 CLI Command Set
192.168.5.13
192.168.5.23
192.168.5.33
Example 3:
To show the PTP client attributes for all clients on port 10 of the expansion shelf
ID=9, and the PTP is in L2 mode:
tp5000> show ptp client exp9 port 10 all
Response 3:
IP Address VLAN PRI
0.0.0.0
0.0.0.0
0.0.0.0
Note: Only Ethernet L2 is supported in expansion shelves until future
release, and the IP address field is filled as 0.0.0.0
Level : Config and Admin only
set ptp client-disconnect
Use this command to disconnect a PTP client using its clock ID,
Command Syntax:
set ptp client-disconnect ioc-[x] <client-clock-ID-value>
Example:
To disconnect the PTP client on IOC1-1 with clock ID value of
0A:11:22:33:44:55:66:77
tp5000> set ptp client-disconnect ioc-1
0A:11:22:33:44:55:66:77
Level : Config and Admin
216 TimeProvider 5000 User's Guide
0 0 00:B0:AE:FF:FE:01:1A:85
0 0 00:B0:AE:FF:FE:01:1B:85
0 0 00:B0:AE:FF:FE:01:1C:85
Clock Id
0 0 00:B0:AE:FF:FE:01:1A:85 D
0 0 00:B0:AE:FF:FE:01:1B:85 D
0 0 00:B0:AE:FF:FE:01:1C:85 D
:
D 0 0
D 0 0
D 0 0
Mode Ann Sync Delay
0 0 -6
0 0 -6
0 0 -6
098-00028-000 Revision F – May, 2012
-6
-6
-6