Tp E10 - Output Connections For Ptp/Synce; Tp E10 - Output Connection For 1Pps Signal; Timeprovider E10 Synchronization And Timing Connections - Symmetricom TimeProvider 5000 User Manual

TimeProvider E10 Synchronization and Timing Connections

The TimeProvider 5000 features 16 SFP output ports (see
ports can provide the following signal types:
PTP (IEEE-1588 2008)

SyncE (only accessible with optical SFP)

TP E10 - PTP/SyncE Connections
The TP E10 expansion shelf features 16 SFP output ports (see
ports can provide the following signal types:
PTP (IEEE-1588 2008)

SyncE (only accessible with optical SFP)

These ports are dedicated output ports with PTP signals that meet the IEEE-1588
v2 specifications. As with the two PTP ports on each TP 5000 IOC card, these 16
ports require Ethernet SFP connectors.
Figure 2-22. TP E10 - Output Connections for PTP/SyncE
Only the SFP transceivers in
SFP transceivers are not supported and may cause the TP E10 expansion shelf to
not comply with regulatory requirements. SyncE is only available with optical SFP
transceivers.
Since the TP E10 expansion shelf uses PTP multicast, all 16 ports should be on
isolated Ethernet networks. Otherwise, only one of the ports will be the active
grandmaster due to the IEEE-1588 BMC algorithm
TP E10 - 1PPS Connection
The TP E10 expansion shelf also has an SMA connector that is a dedicated output
port with a 1PPS signal.
Figure 2-23. TP E10 - Output Connection for 1PPS Signal
098-00028-000 Revision F – May, 2012
Table 2-4 are recommended and supported. Other
Chapter 2 Installing
Signal Connections
Figure 2-22). These
Figure 2-22). These
TimeProvider 5000 User's Guide 81