Symmetricom TimeProvider 5000 User Manual page 235

show ref
Use this command to display the system's reference mode and manual input
reference.
Command Syntax:
show ref
Example:
tp5000> show ref
Response:
Reference Info
-------------------------------------------------------------------------------
| Reference | Ref
| | State |
|-----------|-------|----------|-------|------------|-----------|-------------|
| GNSS |enable | 1
|...........|.......|..........|.......|............|...........|.............|
| GPS |enable | 2
|...........|.......|..........|.......|............|...........|.............|
| PPS-TOD-1 |enable | 3
|...........|.......|..........|.......|............|...........|.............|
| PPS-TOD-2 |enable | 4
|...........|.......|..........|.......|............|...........|.............|
| Input-1 |enable | 7
|...........|.......|..........|.......|............|...........|.............|
| Input-2 |enable | 8
|...........|.......|..........|.......|............|...........|.............|
Reference Mode
Reference Criteria
Level : User, Config, and Admin
098-00028-000 Revision F – May, 2012
| Priority | PQL | PQL Config | PQL Input |
| State |
|disable| 1
|disable| 1
|disable| 1
|disable| 1
|disable| 3
|disable| 3
- time
- priority
TimeProvider 5000 CLI Command Set
Value | Value
| 1
| 1
| 1
| 1
| 15
| 15
TimeProvider 5000 User's Guide 235
Chapter 3
Reference |
| Status |
|disqualified |
|selected |
|disqualified |
|disqualified |
|disqualified |
|disqualified |