Symmetricom TimeProvider 5000 User Manual page 200

Chapter 3
TimeProvider 5000 CLI Command Set
-------------------------------------------------------------------
| Status
|----------------------------------------------|-------------------|
| Port status
|.................... |.........................|...................|
| PPS status
|.................... |.........................|...................|
|PPS phase offset(ns) |
|.................... |.........................|...................|
| Clock source type
|.................... |.........................|...................|
| Clock source status |
|.................... |.........................|...................|
| Accuracy
|.................... |.........................|...................|
| Alarm
|.................... |.........................|...................|
Level : User, Config, and Admin
set pps-tod
Function: to configure the pps-tod input ports state, the priority level, the
cable-delay compensation.
Command Syntax:
To provision the state for the specified 1PPS+TOD port:

set pps-tod
To provision the priority of the 1PPS+TOD input port:

set pps-tod
To provision the cable-delay of pps-tod port:

set pps-tod
To set the forced PQL state for the specified 1PPS+TOD port

set pps-tod pql-state {port1 | port2} {enable | disable}
To set the forced PQL value for the specified 1PPS+TOD port

set pps-tod pql-value port {port1 | port2} <pql-value>
Ranges:
priority = 1 — 16
cable-delay = 0 — 200000 ns, 12.5 ns resolution
pql-value= 1 — 3
Example 1:
200 TimeProvider 5000 User's Guide
| Port 1
| normal
| normal
10
| 0x00
0x00
| <value>
| 0x00
state {port1 | port2} {enable | disable}
priority {port1 | port2} <1 - 16 >
cable-delay {port1 | port2} <value>
| Port 2
| disabled|error |
| n/a
| n/a
| n/a
| n/a
| n/a
| n/a
098-00028-000 Revision F – May, 2012
|
|
|
|
|
|
|