Installation Completeness Checklist; Installation Check List - Symmetricom TimeProvider 5000 User Manual

The unit is now powered up.

Installation Check List

To verify that the installation of the TimeProvider 5000 is complete, perform the
checks and procedures in
Table 2-14. Installation Completeness Checklist
Ensure the TimeProvider 5000 chassis is securely attached to mounting rack
Ensure that the appropriate modules (and filler panels if needed) are installed
Verify that all power and ground wires are installed correctly and securely
Verify that all communications cables are properly installed
Verify that all input and output cables are properly installed
Applying Power to the TimeProvider 5000
The TimeProvider 5000 is not equipped with a Power switch. DC power is controlled
by a power distribution panel. After installing the unit in a rack and making the
necessary connections described in previous sections, turn on power at the
distribution panel.
The TP E10 and TP E30 expansion shelves are not equipped with Power switches.
DC power is controlled by a power distribution panel. After installing a unit in a rack
and making the necessary connections described in previous sections, turn on
power at the distribution panel.
Normal Power Up Indications
As the TimeProvider 5000 powers up and begins normal operation, the
and IMC module LEDs all turn on. After the module self-test is complete and the
module firmware is operational, the LED states may change to indicate the
appropriate state or status.
As the TP E10 or TP E30 expansion shelves powers up and begins normal
operation, the LEDs all turn on. After the self-test is complete and expansion shelf
firmware is operational, LED states may change to indicate appropriate state or
status.
Table 2-15 provides a description of the module LEDs.
description of the expansion shelf LEDs.
098-00028-000 Revision F – May, 2012
Table 2-14.
Operation
Chapter 2 Installing
Installation Check List
Complete
IOC module
Table 2-16 provides a
TimeProvider 5000 User's Guide 89