Command Syntax - Symmetricom TimeProvider 5000 User Manual

Chapter 3
TimeProvider 5000 CLI Command Set
show ptp-probe
This command is used to begin PTP packet measurements. This command can also
be used to display the Probe configuration, which includes Grandmaster Clock ID, IP
address and VLAN (if applicable), interval rate, and lease duration.
Note: The Probe option must be purchased to enable the
functionality of all "ptp-probe" commands.

Command Syntax:

To display the probe configuration data:

show ptp-probe config ioc1-[y]
To begin gathering data with the probe:

show ptp-probe data ioc1-[y]
To stop gathering data with the probe, press the Enter key.
Example 1:
To display the configuration data of the Probe on port 2
tp5000> show ptp-probe config ioc1-2
Example 2:
To display the test data from port 1 of the Probe 
tp5000> show ptp-probe data ioc-1
Response :
F,00011,1229541029,099868364,1229541029,099881920,0000000000,
B,00011,1229541029,562553320,1229541029,562539700,0000000000,
F,00012,1229541030,099868364,1229541030,099881776,0000000000,
B,00012,1229541030,562553320,1229541030,562539700,0000000000,
F,00013,1229541031,099868364,1229541031,099881936,0000000000,
B,00013,1229541031,562553288,1229541031,562539700,0000000000,
F,00014,1229541032,099868364,1229541032,099881776,0000000000,
B,00014,1229541032,562553288,1229541032,562539700,0000000000,
Level : User, Config and Admin
226 TimeProvider 5000 User's Guide
where
y= 1|2, the port number on IOC1
098-00028-000 Revision F – May, 2012