Table of Contents
Advertisement
Appendix F PTP Probe Option
Controlling the Probe With TimeMonitor PDV
In Terminal mode, the main display area of the TM PDV interface will function as a
simplified terminal.
Complete commands, with proper syntax, must be used with either approach. The
Tab completion feature for TP 5000 CLI commands is not available through the
TimeMonitor PDV interface in either Terminal or Command mode.
See the TimeProvider 5000 User's Guide for details about CLI commands and
associated syntax.
Command Mode
Use the following procedure to enter CLI commands manually with TimeMonitor
PDV in Command mode:
1.
Select the radio button for the Command mode.
2.
Click the Login button to login to the TP 5000 probe.
3.
Enter the Username and Password for the TP 5000 probe when prompted in
the main display area of the screen.
4.
In the Command field, enter the desired CLI command, as the following
example image illustrates.
5.
Click the Send button to send the command to the TP 5000 probe for
execution. Any response will be shown in the main display area of the screen.
Terminal Mode
To display the IP address for the MGMT port on the TP 5000 Probe's IMC card,
enter the command "show ip status imc". Use the following procedure to enter CLI
commands manually with TimeMonitor PDV in Terminal mode:
1.
Select the radio button for the Command mode.
The "Login:" prompt will appear in the main display. All other fields and buttons
are greyed out, except for the Check, Start, and Clear buttons.
2.
Enter the Username for the TP 5000 Probe at the prompt in the main display.
Click the Enter button on user's computer.
508 TimeProvider 5000 User's Guide
098-00028-000 Revision F – May, 2012
Advertisement
Chapters
Table of Contents
Troubleshooting
