Symmetricom TimeProvider 5000 User Manual page 158

Chapter 3
TimeProvider 5000 CLI Command Set
show ip
This command displays the Host, Mask, and Gateway IP addresses for Ethernet
interfaces on the specified module. It also indicates if DHCP is enabled and if the
port is enabled.
Command Syntax:
To show the configuration of the Ethernet interfaces for the specified module

(some settings will only be implemented after restarting the IP interface):
show ip config {imc | ioc1 | exp[0-9]}
To show the current status of the Ethernet interfaces for the specified module:

show ip status {imc | ioc1 | exp[0-9]} [vlan-id <vlan>]
Note: Packet and byte counts do not include most PTP and NTP
packets.
Defaults:
See Table B-19
See Table B-25
Example 1:
To display the configuration of the Ethernet interfaces for the IMC module 
tp5000> show ip config imc
Response 1:
MGMT PORT PARAMETERS
IP mode
IP state
Example 2:
To display the configuration of the Ethernet interfaces for the IOC1 module 
tp5000> show ip config ioc1
Response 2:
ETH1 PORT PARAMETERS
158 TimeProvider 5000 User's Guide
for default IP address for the IMC module.
for default IP address for IOC1 and IOC2 modules.
: dhcp
: enable
098-00028-000 Revision F – May, 2012