Table of Contents
Advertisement
Table 4-9. Option 2 - SSM Mapping to QL and clockClass per G.781 and G.8265-1 (Continued)
Option 2 SSM (hex)
22FF
30FF
Others (or absent)
PTP Parameters
Unicast (Telecom-20008 and ITU-G.8265.1)
The "set ptp unicast dynamic" command is used to provision parameters specific to
unicast dynamic. See
commands.
and
Table B-31
The "set ptp unicast static" command is used to provision parameters specific to
unicast static. See
commands. See
Table B-31
for defaults and ranges.
The TP5000 can be configured with both dynamically-allocated and static clients at
the same time.
Unicast - Dynamic
The default condition for Unicast negotiate is "Enable", with a lease duration of 1000
seconds.
Use the following procedure to configure Port 1 of IOC1 for PTP Unicast dynamic
clients, with a lease duration of 250 seconds:
1. Login at the Admin or Config-user level.
2. Type
set ptp profile ioc1-1 telecom-2008
3. Type
set ptp unicast dynamic negotiate ioc1-1 enable
4. Type
set ptp unicast dynamic lease-duration ioc1-1 250
Enter.
098-00028-000 Revision F – May, 2012
Clock QL
QL-SMC
QL-DUS
Invalid
Figure 4-14
SeeTable 4-12
for descriptions of the Unicast – Dynamic parameters,
for defaults and ranges.
Figure 4-15
for the hierarchy of the "set ptp unicast static"
Table 4-13
for descriptions of the Unicast – Static parameters, and
PTP clockClass
106
110
n/a
for the hierarchy of the "set ptp unicast dynamic"
and press Enter.
Chapter 4 Provisioning
Provisioning PTP
PQL
8
9
15
and press Enter.
and press
TimeProvider 5000 User's Guide 295
Advertisement
Chapters
Table of Contents
Troubleshooting
