Provisioning Alarms - Symmetricom TimeProvider 5000 User Manual

Chapter 4 Provisioning

Provisioning Alarms

Example
1. Login at the Admin or Config-user level (see
2. Type
show ref
3. Type
set ref mode frequency
4. Type
set clock date-time <value>
format yyyy-mm-dd,hh:mm:ss.
5. Type
sync tod-source
Provisioning Alarms
This section describes the commands used to provision and manage alarms in the
TimeProvider 5000. The user can provision the alarms to be enabled or disabled
and set thresholds to turn the alarms on and off. For a list of all alarms, see
Appendix A, System
Software commands allow you to perform the following:
Provision the severity level

Provision the alarm (enable or disable)

Show current alarm settings

Show current alarms

Display alarm status

Alarms are also indicated by LEDs on the IOC and IMC modules.
Note: Disabling an input port will clear all alarms and events related
to the port.
346 TimeProvider 5000 User's Guide
and press Enter to check the reference mode.
and press Enter.
now and press Enter.
Messages.
Logging In, on page 275).
and press Enter. Enter the value in
098-00028-000 Revision F – May, 2012