Unfused Image - Xerox Phaser 6180 Service Manual
Color
Hide thumbs
Also See for Phaser 6180:
- User manual (158 pages) ,
- Quick use manual (6 pages) ,
- Specifications (4 pages)
Table of Contents
Advertisement
Print-Quality Troubleshooting
Unfused Image
Initial Actions
5-54
The toner image is not completely fused to the paper. The image easily rubs
off.
■
Check the paper transfer path.
■
Ensure there are no debris on the transfer path.
Troubleshooting Reference Table
Applicable Notes
Fuser, PL6.1.10
■
Print Cartridge (C/M/Y/K),
■
PL5.1.18-21)
MCU Board, PL9.1.20
■
Warning
Ensure to wait for the Fuser to cool down before starting the procedure.
Troubleshooting Procedure Table
Step
Actions and Questions
1
Check the paper condition. Is the
paper dry, recommended type, and
loaded in the correct position?
Check the Print Cartridge (C/M/Y/K)
2
for damages. Is the Print Cartridge
damaged?
Example Print
ABCDE abcde 12345
Yes
Go to step 2.
Go to step 3.
Phaser 6180 Color Laser Printer Service Manual
s6180-330
No
Replace the
paper.
Replace the
Print Cartridge
(page 8-9).
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Phaser 6180 and is the answer not in the manual?
Questions and answers
Yellow ink is leaking onto my documents. Is there a way to print by removing the yellow ink cartridge?
blinking green and stays at configuration page. Does print page. If you cancel it gets stuck at cancelling job and never goes from that screen. Powering off for a while and turning back on with same results. Can not set nvram through menu as it says it has a job that is currently running.