Blank Print (No Print) - Xerox Phaser 6180 Service Manual
Color
Hide thumbs
Also See for Phaser 6180:
- User manual (158 pages) ,
- Quick use manual (6 pages) ,
- Specifications (4 pages)
Table of Contents
Advertisement
Blank Print (No Print)
Phaser 6180 Color Laser Printer Service Manual
The entire image area is blank.
Initial Actions
■
Check the paper transfer path.
■
Ensure there are no debris on the transfer path.
Troubleshooting Reference Table
Applicable Parts
Dispenser, PL5.1.12
■
Print Cartridge (C/M/Y/K),
■
PL5.1.18-21
Laser Unit, PL5.1.2
■
MCU Board, PL9.1.20
■
Image Processor Board, PL9.1.27
■
Troubleshooting Procedure Table
Step
Actions and Questions
1
Check the Print Cartridge (C/M/Y/K)
for damages. Is the Print Cartridge
damaged?
Check the paper condition.
2
Is the paper dry, recommended type,
and loaded in the correct position?
Perform Test Print (Cyan 20%,
3
Magenta 20%, Yellow 20%, and Black
20%):
Does the image quality improve?
Example Print
Service Mode
>
Test
Print.
Print-Quality Troubleshooting
s6180-318
Yes
No
Go to step 2.
Replace the
Print Cartridge
(page 8-9).
Go to step 3.
Replace the
paper.
Complete.
Go to step 4.
5-27
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Phaser 6180 and is the answer not in the manual?
Questions and answers
Yellow ink is leaking onto my documents. Is there a way to print by removing the yellow ink cartridge?
blinking green and stays at configuration page. Does print page. If you cancel it gets stuck at cancelling job and never goes from that screen. Powering off for a while and turning back on with same results. Can not set nvram through menu as it says it has a job that is currently running.