Optional Feeder Motor Error - Xerox Phaser 6180 Service Manual

Error Messages and Codes

Optional Feeder Motor Error

Applicable Chain Link
Initial Actions
3-92
The Optional Feeder Motor has failed.
■
Chain Link 072-216: Option Feeder Motor Fail
■
Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
MCU Board, PL9.1.20
■
Feeder Kit, PL3.2.1
■
Feed Roll, PL12.1.9
■
Retard Roll, PL12.3.10
■
Right Side Harness, PL10.1.15
■
Tray 3 Feeder Drive, PL12.2.10
■
C2 Motor Harness, PL12.2.9
■
Feeder Unit Harness, PL12.2.3
■
Tray 3 Feeder Board, PL12.2.6
■
Optional 550-Sheet Feeder, PL12.1.1
■
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the paper tray for correct
installation. Is the tray correctly
installed?
Does the error still occur?
2
3 Check the Feed Rollers and Retard
Rollers for rotation. Do the Rollers
rotate smoothly?
Check the wiring harness connectors
4
P/J422, P/J4221, and P/J4222
between the Tray 3 Feeder Board and
the Tray 3 Feeder Drive.
Perform the Tray 3 Feed Motor test
5
(page 4-45): Service Mode
Diag > Motor Test
Motor.
Wiring and Plug/Jack Map References
"Map 2 - Laser Unit" on page 10-11
■
"Map 4 - LVPS and MCU Board" on
■
page 10-13
"Map 6 - Optional 550-Sheet Feeder" on
■
page 10-15
"Optional 550-Sheet Feeder Wiring
■
Diagram" on page 10-50
Yes
Go to step 3.
Go to step 3.
Go to step 4.
Go to step 5.
Replace the
> Engine MCU Board
> Tray 3 Feed (page 8-87).
Phaser 6180 Color Laser Printer Service Manual
No
Reseat the
paper tray. Go
to step 2.
Complete.
Replace the
defective
Roller(s).
Reconnect the
connectors. Go
to step 4.
Go to step 6.