Jam At Duplexer - Xerox Phaser 6180 Service Manual

Jam at Duplexer

Phaser 6180 Color Laser Printer Service Manual
The Duplex Jam Sensor indicates the paper did not reach the sensor on time
or that paper remains in the Chute Assembly Out.
Applicable Chain Link
■
Chain Link
Initial Actions
■
Check for obstruction or debris in the Exit Chute Out or paper path.
■
Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Registration Sensor Harness,
■
PL3.2.37
Fuser Harness, PL6.1.11
■
Right Side Harness, PL10.1.15
■
Feeder Unit, PL3.2.1
■
MCU Board, PL9.1.20
■
Main Drive, PL8.1.2
■
Drive Assembly, PL8.1.7
■
Front Cover Harness, PL1.2.11
■
Exit Out Chute, PL6.1.1
■
Duplex Gate Chute, PL6.1.13
■
Duplex Harness, PL11.1.18
■
Duplex Unit, PL11.1.1
■
Troubleshooting Procedure Table
Step Actions and Questions
Check the Front Cover Latch. Open and
1
close the Front Cover.
Does the error still occur?
Reseat the Fuser. Does the error still
2
occur?
3 Reseat the Duplex Gate Chute. Does
the error still occur?
Check the Duplex Gate Chute for
4
correct installation. Reseat the Duplex
Gate Chute. Does the error still occur?
077-907: Jam at Duplexer
Wiring and Plug/Jack Map Reference
"Map 1 - Electrical and Drive" on
■
page 10-10
"Map 2 - Laser Unit" on page 10-11
■
"Map 4 - LVPS and MCU Board" on
■
page 10-13
"Map 5 - Duplex Unit" on page 10-14
■
"Tray 1 (MPT) and Registration" on
■
page 10-32
"Main Drive" on page 10-34
■
"Feeder" on page 10-36
■
"Fuser" on page 10-46
■
"Duplex Wiring Diagram" on page 10-52
■
Error Messages and Codes
Yes No
Go to step 2. Complete.
Go to step 3. Complete.
Go to step 4. Complete.
Go to step 5. Replace the
Duplex Gate
Chute
(page 8-64).
3-29