Duplex Error - Xerox Phaser 6180 Service Manual

Error Messages and Codes

Duplex Error

Applicable Chain Link
Initial Actions
3-96
The Duplex Unit has failed.
■
Chain Link 077-215: Duplexer Error
■
Inspect the Duplex to ensure that it is free of obstructions.
■ Cycle printer power.
■
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
MCU Board, PL9.1.20
■
Duplex Unit Harness, PL11.1.18
■
Right Side Harness, PL10.1.15
■
Front Cover Harness, PL1.2.11
■
Duplex Unit, PL11.1.1
■
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the Duplex for correct
installation. Is the Duplex correctly
installed?
Does the error still occur?
2
3 Check the wiring harness connectors
P/J27, P/J272, P/J2720, and P/J428
between the Duplex Board and the
MCU Board. Are the connectors
securely connected?
4 Does the error still occur?
5 Check the Duplex Unit Harness for
continuity.
1. Disconnect P/J428 and P/J2720.
2. Check continuity between P/J428
<=> P/J2720.
Wiring and Plug/Jack Map References
"Map 1 - Electrical and Drive" on
■
page 10-10
"Map 2 - Laser Unit" on page 10-11
■
"Map 4 - LVPS and MCU Board" on
■
page 10-13
"Map 5 - Duplex Unit" on page 10-14
■
"Duplex Wiring Diagram" on page 10-52
■
Yes
Go to step 3.
Go to step 3.
Go to step 5.
Go to step 5.
Go to step 6.
Phaser 6180 Color Laser Printer Service Manual
No
Reseat the
Duplex. Go to
step 2.
Complete.
Reconnect the
connectors. Go
to step 4.
Complete.
Replace the
Duplex Unit
Harness.