Transfer Unit Crum Error - Xerox Phaser 6180 Service Manual

Transfer Unit CRUM Error

Phaser 6180 Color Laser Printer Service Manual
The Transfer Unit CRUM ID error is detected.
Applicable Chain Link
■ Chain Link
Initial Actions
■
Ensure the Transfer Unit is installed correctly.
■ Cycle printer power.
■
If problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Transfer Unit, PL4.1
■
MCU Board, PL9.1
■
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the Transfer Unit for correct
installation. Is the Transfer Unit correctly
installed?
2 Does the error still occur?
3 Replace the Transfer Unit (page 8-7). Does
the error still occur?
094-330: Transfer CRUM Error
Wiring and Plug/Jack Map References
"Map 1 - Electrical and Drive" on
■
page 10-10
"Map 4 - LVPS and MCU Board" on
■
page 10-13
"Xerographic" on page 10-40
■
Error Messages and Codes
Yes No
Go to step 3. Reseat the
Transfer Unit.
Go to step 2.
Go to step 3. Complete.
Replace the Complete.
MCU Board
(page 8-87).
3-51