Jam at Tray 3 (Feeder 2 Jam)
Phaser 6180 Color Laser Printer Service Manual
Paper fed from Tray 3 did not reach the Registration Sensor on time.
Applicable Chain Link
■
Chain Link
Initial Actions
■
Try picking paper from a different tray.
■
Check the paper path for obstructions or debris.
■
Cycle printer power.
■
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
MCU Board, PL9.1.20
■
Right Side Harness, PL10.1.15
■
C2 Chute Harness, PL12.2.7
■
C2 Turn Harness, PL12.2.8
■
Optional Feeder, PL12.1.8
■
Optional 550-Sheet Feeder, PL12.1.1
■
Optional Feeder Harness, PL12.2.3
■
Roll Assy Feed (Feed Roll), PL12.1.9
■
Troubleshooting Procedure Table
Step
Actions and Questions
1
Check the paper condition. Is the
paper damaged?
2
Check the paper setting. Does the
paper in use match with the paper
settings on the Control Panel?
3
Does the error still occur?
Reseat the paper tray. Does the error
4
still occur?
072-100: Jam at Tray 3
Wiring and Plug/Jack Map References
"Map 2 - Laser Unit" on page 10-11
■
"Map 4 - LVPS and MCU Board" on
■
page 10-13
"Map 6 - Optional 550-Sheet Feeder" on
■
page 10-15
"Main Drive" on page 10-34
■
"Optional 550-Sheet Feeder Wiring
■
Diagram" on page 10-50
Error Messages and Codes
Yes
No
Replace the
Go to step 2.
paper.
Go to step 3.
Correct the
paper settings
on the Control
Panel. Go to
step 3.
Go to step 4.
Complete.
Go to step 5.
Complete.
3-13