Xerox Phaser 6180 Service Manual page 167

Phaser 6180 Color Laser Printer Service Manual
Troubleshooting Procedure Table (continued)
Step Actions and Questions
4 Perform the Toner Motor test:
Mode > Engine Diag
Toner Motor.
Yellow Toner Motor (page 4-47)
■
Magenta Toner Motor (page 4-48)
■
Cyan Toner Motor (page 4-49)
■
Black Toner Motor (page 4-50)
■
While testing the Toner Motor, close
the Interlock Harness.
5 Check the Dispenser wiring harness
connectors.
Yellow: P/J18 and P/J181
■
Magenta: P/J18 and P/J182
■
Black: P/J18 and P/J183
■
Cyan: P/J18 and P/J184
■
Are the connectors securely
connected?
Does the error still occur?
6
7 Check the Top LV Harness for
continuity.
1. Disconnect P/J Harnesses.
Yellow: P/J18 and P/J181
■
Magenta: P/J18 and P/J182
■
Black: P/J18 and P/J183
■
Cyan: P/J18 and P/J184
■
2. Check continuity between P/J
connectors:
Yellow: P/J18 <=> P/J181
■
Magenta: P/J18 <=> P/J182
■
Black: P/J18 <=> P/J183
■
Cyan: P/J18 <=> P/J184
■
Check the Dispenser signal.
8
1. Disconnect P/J18 from the MCU
Board.
2. When the Interlock Switch is
activated, is there +24 V across:
Ground <=> P/J18-A1/P/J18-A2
■
(Yellow)
Ground <=> P/J18-A7/P/J18-A8
■
(Magenta)
Ground <=> P/J18-B1/P/J18-B2
■
(Black)
Ground <=> P/J18-B7/P/J18-B8
■
(Cyan)
Yes
Service Check the gear
> Motor Test > of the Auger for
damage. If the
gear is
damaged,
replace the
Dispenser
(page 8-56).
Go to step 6.
Go to step 7.
Go to step 8.
Replace the
Dispenser
(page 8-56).
Error Messages and Codes
No
Go to step 5.
Reconnect the
connectors. Go
to step 6.
Complete.
Complete.
Replace the
MCU Board
(page 8-87).
3-41