Laser Error - Xerox Phaser 6180 Service Manual

Laser Error

Phaser 6180 Color Laser Printer Service Manual
An error was detected in the Laser Unit.
Applicable Chain Link
■ Chain Link
Initial Actions
■
Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Laser Unit, PL5.1.2
■
MCU Board, PL9.1.20
■
Troubleshooting Procedure Table
Step Actions and Questions
Check the Laser Unit for correct
1
installation. Is the Laser Unit correctly
installed?
2 Does the error still occur?
Check the wiring harness connectors
3
P/J12 and P/J121 between the MCU
Board and the Laser Unit. Are the
connectors securely connected?
Does the error still occur?
4
5 Check the MCU Board for correct
installation. Is the MCU Board
correctly installed?
6 Does the error still occur?
Replace the Laser Unit (page 8-50).
7
Does the error still occur?
061-370: Laser Error (ROS Failure)
Wiring and Plug/Jack Map References
"Map 2 - Laser Unit" on page 10-11
■
"Map 4 - LVPS and MCU Board" on
■
page 10-13
"Laser Unit" on page 10-38
■
Error Messages and Codes
Yes No
Go to step 3. Reinstall the
Laser Unit. Go
to step 2.
Go to step 3. Complete.
Go to step 5 Reconnect the
connectors. Go
to step 4.
Go to step 5. Complete.
Go to step 7. Reseat the MCU
Board. Go to
step 6.
Go to step 7. Complete.
Replace the Complete.
MCU Board
(page 8-87).
3-83