Insert Transfer Unit - Xerox Phaser 6180 Service Manual

Insert Transfer Unit

Phaser 6180 Color Laser Printer Service Manual
The printer does not detect the Transfer Unit.
Applicable Chain Link
■ Chain Link
Initial Actions
■
Remove and reseat the Transfer Unit.
■ Cycle printer power.
■
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Transfer Unit, PL4.1.1
■
MCU Board, PL9.1.20
■
Front Cover Harness, PL1.2.11
■
Right Side Harness, PL10.1.15
■
Troubleshooting Procedure Table
Step Actions and Questions
1 Is the Transfer Unit installed correctly?
Does the error still occur?
2
3 Check the wiring harness connectors P/J27,
P/J272, and P/J2721 between the MCU
Board and the Transfer Unit. Are the
connectors securely connected?
4 Check the Right Side Harness for continuity.
1. Disconnect P/J27 and P/J272.
2. Check continuity between P/J27 <=> P/
J272.
5 Check the Front Cover Harness for
continuity.
1. Disconnect P/J272 and P/J2721.
2. Check continuity between P/J272 <=> P/
J2721.
6 Replace the Transfer Unit (page 8-7). Does
the error still occur?
094-910: Insert Transfer Unit
Wiring and Plug/Jack Map References
"Map 1 - Electrical and Drive" on
■
page 10-10
"Map 4 - LVPS and MCU Board" on
■
page 10-13
"Xerographic" on page 10-40
■
Error Messages and Codes
Yes No
Go to step 2. Reseat the
Transfer Unit.
Go to step 3. Complete.
Go to step 4. Reconnect
the
connectors.
Go to step 5. Replace the
Right Side
Harness.
Go to step 6. Replace the
Front Cover
Harness.
Replace the Complete.
MCU Board
(page 8-87).
3-49