Xerox Phaser 6180 Service Manual page 428

Service Parts Disassembly
38
5. Remove the E-ring securing the bearing on the left and right sides of the
Roll, and shift the bearing toward the inside.
6. Shift the Roll to the right and pull out the left side shaft section of the Roll
from the bearing. Pull the Tray 1 (MPT) Roll out toward the lower left side
to remove it.
Replacement Note Replacement Note
Pay attention to the orientation of the Bearings. The right side of the
Bearing (PL3.1.6) is Black; the left side of the Bearing (PL3.1.13) is
White.
Ensure the D cut surface of the Shaft faces upward which makes the
installation process easier.
Attach the elliptical side of the mounting section of the MPT Feed
Spring to the Gear.
Phaser 6180 Color Laser Printer Service Manual
s6180-026