Imaging Unit Errors; Replace Imaging Unit/Phd Crum Error - Xerox Phaser 6130 Service Manual

Imaging Unit Errors

Replace Imaging Unit/PHD CRUM Error

Phaser 6130 Color Laser Printer Service Manual
Applicable Chain Link
091-916: Imaging Unit CRUM Error
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
MCU Board, PL8.2.13
Imaging Unit, PL4.1.21
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the Imaging Unit type
Is the correct Imaging Unit installed in
the 6130N?
Does the error still occur when the
2
power is turned OFF and ON?
3 Reseat the Imaging Unit.
Does the error still occur when the
power is turned OFF and ON?
Check the connectors to the MCU
4
Board and Imaging Unit.
Are P/J42 and P/J422 connected
correctly?
Does the error still occur when the
5
power is turned OFF and ON?
6 Replace the Imaging Unit (page 8-8).
Does the error still occur when the
power is turned OFF and ON?
Error Messages and Codes
Wiring and Plug/Jack Map References
"Map 1 - Transfer Unit, Control Panel,
Imaging Unit, Dispenser, Fuser" on
page 10-8
"Map 3 - LVPS, Drive Motors, I/P Board,
AC Power" on page 10-10
Yes No
Go to step 3. Replace with the
correct Imaging
Unit, then go to
step 2.
Go to step 3. Complete
Go to step 4. Complete
Go to step 6. Reconnect the
connector(s) P/
J42 and/or P/
J422 securely,
then go to step
5.
Go to step 6. Complete
Replace the Complete
MCU Board.
(page 8-59)
3-71