Transfer Unit Crum Error - Xerox Phaser 6280 Service Manual

Transfer Unit CRUM Error

Phaser 6280 Color Laser Printer Service Manual
The Transfer Unit CRUM ID error is detected.
Applicable Chain Link
Chain Link
Initial Actions
Ensure the Transfer Unit is installed correctly.
Cycle printer power.
If problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Transfer Unit, PL4.1.1
MCU Board, PL9.1.20
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check the Transfer Unit for correct
installation.
2. Is the Transfer Unit correctly installed?
2 Does the error still occur?
1. Replace the Transfer Unit (page 8-8).
3
2. Does the error still occur?
094-330: IOT CRUM ID Error
Wiring and Plug/Jack Map References
Error Messages and Codes
Yes No
Go to step 3. Reseat the
Transfer Unit
(page 8-8).
Go to step 2.
Go to step 3. Complete.
Replace the Complete.
MCU Board
(page 8-86).
3-73