Setpoint Exchange (S9); Signals To Axis/Spindle (Db31; Signals From Axis/Spindle (Db31 - Siemens sinumerik 840D sl Function Manual

Detailed description

2.6 Setpoint Exchange (S9)

DB31, ...
DBX99.3
Signal state 0 or edge
change 1 → 0
Signal irrelevant ...
Corresponding to ....
2.6 Setpoint Exchange (S9)
2.6.1

Signals to axis/spindle (DB31, ...)

DB31, ...
DBX24.5
Edge evaluation: No
Signal state = 1
Signal state = 0
2.6.2

Signals from axis/spindle (DB31, ...)

DB31, ...
DBX96.5
Edge evaluation: No
Signal state 1
Signal state 0
Signal relevant for ...
16
Axis accelerated
The following axis acceleration in the axis grouping of the electronic gear is less than the
operating value described above.
Without electronic gear.
the following machine data:
MD37560 $MA_EG_ACC_TOL (threshold value for "Accelerate axis")
MD32300 $MA_MAX_AX_ACCEL (axis acceleration)
Activate setpoint exchange
Signal(s) updated: Cyclic
Request to axis to take over drive control.
Request to axis to relinquish drive control.
Status of setpoint exchange
Signal(s) updated: Cyclic
The axis has taken over control of the drive.
The axis has relinquished control of the drive.
All axes involved in setpoint exchange.
Special functions: NC/PLC interface signals (Z3)
Function Manual, 11/2006, 6FC5397-2BP10-2BA0