Siemens sinumerik 840D sl Function Manual page 497

Detailed description
2.1 OEM transformations
3. In the "OEM" directory, create the file "DPSIM.INI" with the following contents:
4. Close the HMI application.
5. Launch the HMI application.
6. In the directory for the manufacturer cycles, create the file "TRAORI.SPF" with the
7. In the directory for the manufacturer cycles, create the file "TRACON.SPF" with the
Note
The "TRAORI.SPF" and "TRACON.SPF" manufacturer cycles created under 6. and 7.
must not be loaded onto the NC.
8. Start the simulation.
9. Run a data comparison for the cycles after the simulation has started up:
8
[PRELOAD]
CYCLES=1
CYCLEINTERFACE=0
following contents:
PROC TRAORI(INT II)
RET
following contents:
PROC TRACON(INT II)
RET
– HMI Advanced: Data comparison > Compare cycles
Note
At least the password for protection level 3 "End user: Service" is needed for the data
comparison.
Special functions: Simulation of Compile Cycles (TE02)
Function Manual, 11/2006, 6FC5397-2BP10-2BA0