2.1.1
Corners for circumferential milling
Outside corners/inside corners
Outside corners and inside corners must be treated separately. The terms inside corner and
outside corner are dependent on the tool orientation. When the orientation changes at a
corner, for example, the corner type may change while machining is in progress. Whenever
this occurs, the machining operation is aborted with an error message.
Figure 2-3
Figure 2-4
Special functions: 3D Tool Radius Compensation (W5)
Function Manual, 11/2006, 6FC5397-2BP10-2BA0
Corner type
Change of corner type during machining
Detailed description
2.1 Circumferential milling
11