Siemens sinumerik 840D sl Function Manual page 482

3.1.3 Loading compile cycles
See sections:
"Loading a compile cycle with HMI Advanced"
"Loading a compile cycle with HMI Embedded"
"Loading a compile cycle from an external computer with WinSCP3"
3.1.4 NCU RESET
When the NCK is rebooted after an NCU reset, the compile cycles are loaded onto the NCK
system software.
You can check the versions of the loaded compile cycles (see "Loading a compile cycle ..."
sections).
3.1.5 Activate technology function
Option
The option bits for the loaded ELF files can be set (see "Activation of the technology
functions in the NCK" section).
Channel activation
The "Activation of the technology functions in the NCK" section describes how the channel
information approved for the individual technologies have to be set in the following machine
data:
MD... $MN_CC_ACTIVE_IN_CHAN_XXX[0]
and
MD... $MN_CC_ACTIVE_IN_CHAN_XXX[1]
The associated MD number is derived from the loading sequence (see: "NCU RESET"
section).
3.1.6 Reactivate NCU RESET
The NCK is rebooted; no alarms should appear.
Special functions: Installation and Activation of Loadable Compile Cycles (TE01)
Function Manual, 11/2006, 6FC5397-2BP10-2BA0
3.1 Transition to newer NCK versions (840D)
Boundary conditions
21