Detailed Description; 3-Axis To 5-Axis Transformation (F2); Signals From Channel (Db21 - Siemens sinumerik 840D sl Function Manual

Detailed description

2.1

3-Axis to 5-Axis Transformation (F2)

2.1.1

Signals from channel (DB21, ...)

DB21, ...
DBX29.4
Edge evaluation: Yes
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Signal irrelevant for ...
Additional references
DB21, ...
DBX33.6
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Signal irrelevant for ...
Additional references
DB21, ...
DBB232
Edge evaluation:
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Special functions: NC/PLC interface signals (Z3)
Function Manual, 11/2006, 6FC5397-2BP10-2BA0
activate PTP traversal
Signal(s) updated:
activate PTP traversal.
Activate CP traversal.
No handling transformations active.
/FB3/ Function Manual, Special Functions; 3-Axis to 5-Axis Transformation (F2)
Transformation active
Signal(s) updated: Cyclic
Active transformation.
Transformation not (no longer) active.
No transformation used.
/PG/ Programming Guide Fundamentals
Number of active G function of G function group 25 (tool orientation reference)
Signal(s) updated:
ORIWKS: The tool orientation is implemented in a workpiece coordinate system and is thus
not dependent on the machine kinematics. This is the default setting.
ORIMKS: The tool orientation is defined in the machine coordinate system and is thus
dependent on the machine kinematics. This is the default setting.
2
7