Siemens sinumerik 840D sl Function Manual page 704

Examples
4.1 General information about start-up
Note
The compile cycles are supplied as loadable modules. The general procedure for installing
such compile cycles can be found in TE0. The specific installation measures for this compile
cycle can be found from Section "Starting up a kinematic transformation" onwards.
HMI software version must be 3.5 or higher. For 810D, an NCK Jeida card with the kinematic
transformation "Handling transformation package" ( P2.3 and higher) must be available and
for the 840D, an NCK-OEM Jeida card (technology card 2 or higher).
The following measures need only be taken for 840D controls, since the "handling
transformation package" is integrated as a standard feature in the 810D.
1. Back up SRAM (840D only)
As the first step in the installation of a compile cycle function for 840D, the technology card is
exchanged for the original card provided in the NCU.
This step is equivalent to any procedure which involves the normal upgrade of your software
platform and requires the deletion of any (battery-supported) static control memory. To avoid
the consequential loss of all data in the SRAM, back up the SRAM before performing the
operation. For a detailed description, please see the Manufacturer/Service Documentation
"SINUMERIK 840D/SIMODRIVE 611D Installation and Start-Up Guide":
1. Enter the machine manufacturer password.
2. Switch to the "Services" operating area.
3. Press the "Series start-up" softkey.
4. Select "NC" and "PLC" as the areas to be saved and enter a name of your choice for the
Special functions: Handling Transformation Package (TE4)
Function Manual, 11/2006, 6FC5397-2BP10-2BA0
archive file to be created on the hard disk. Finish by pressing the RETURN key.
4
63