Siemens sinumerik 840D sl Function Manual page 494

Brief description
1.1 Function
If part programs, which use compile cycles, are simulated on the SINUMERIK user interface
(e.g. HMI Advanced) simulation is aborted and corresponding error messages are issued.
The reason is that compile cycle support has not yet been implemented on the HMI.
The measures described below show how to set up the simulation runtime environment to
enable the simulation of part programs, which use compile cycles, without error messages.
1.2 Requirements
OEM transformations
At least the following software version is required in order to use the functions of OEM
transformations to simulate part programs: SW 6.2.12
Special functions: Simulation of Compile Cycles (TE02)
Function Manual, 11/2006, 6FC5397-2BP10-2BA0
1
5