Siemens sinumerik 840D sl Function Manual page 475

Detailed description
2.1 Loadable compile cycles 840D/840D sl
Dependencies
The following dependencies exist between the interface versions of a compile cycle and the
NCK system software:
• 1st digit of the interface version number
• 2nd digit of the interface version number
Caution
If alarm 7200 is displayed after start-up, this means no compile cycle has been loaded!
2.1.5 Software version of a compile cycle
The SW version of a compile cycle is displayed under:
HMI Advanced:
Diagnosis > Service Display > Version > NCU Version
Display (excerpt)
-------------------------------------------
CC Interface Version:
@NCKOPI . . . .
Loaded Compile Cycles:
Identifier
<
CC start address
_N_<
Code=<
-------------------------------------------
Example:
_N_CLC407IF003001_ELF corresponds to software version 4.7
Note
The display of code and data range start addresses of a compile cycle are provided for
diagnostics purposes only and have no significance in normal operation.
14
The 1st digit of the interface version number of a compile cycle and the NCK system
software must be the same .
The 2nd digit of the interface version number of a compile cycle must be less than or
equal to the 2nd digit of the NCK system software.
Version Generation Data
> < > <
Identifier
><Version>IF<
Address
> Data=<
>
1st digit 2nd digit
>< >_ELF . . .
Address
> . . .
Special functions: Installation and Activation of Loadable Compile Cycles (TE01)
Function Manual, 11/2006, 6FC5397-2BP10-2BA0