Abbott i-STAT 1 System Manual page 69

Hide thumbs Also See for i-STAT 1:

Table of Contents

6. Another "Found New Hardware Wizard" will appear automatically. Select the "Yes, this time

only" radio button and click Next to continue.

7. Select the "Install a software automatically (Recommended)" radio button as previously illus-

trated and click Next.

8. Wait while the "USB Serial Port" driver installs. This may take a few minutes.

9. When the "USB Serial Port" driver installation is complete, click Finish. If the DRC USB driver

installs successfully, you will see a "Found New Hardware" message appear on the PC Taskbar.

10. Select Start → Settings → Control Panel → Performance and Maintenance (if listed) → Sys-

tem to launch the "System Properties" dialog box. Select the Hardware tab, and click "Device

Manager" to show a list of devices.

11. Expand "Ports (COM & LPT)" to list all the COM Ports (as shown above). The newly installed

DRC port is named "USB Serial Port".

12. Right click on the "USB Serial Port" device entry and select Properties. A "USB Serial Port

Properties" dialog box will open. Select the Port Settings tab.

Rev. Date: 14-Mar-14

Art: 728690-01F

Troubleshooting