Abbott i-STAT 1 System Manual page 266

1.14:
When the update is in progress, the following screen will appear
The handheld will have 1's and 0's streaming across the screen signifying that it is receiving the
software.
Do not move the handheld until the success screen is displayed.
1.15:
Run the Electronic Simulator in the handheld. When the simulator finishes, PASS should
.
be displayed
Note: If PASS is not displayed, re-run the Electronic Simulator. If the repeated Electronic Simu-
lator attempt fails, contact APOC Technical Support. For additional information on running the
electronic simulator, see Section 14 of the i-STAT 1 System Manual.
Congratulations. The process for updating the first
Review the options below for additional instructions.
If there are no additional handhelds to update, the process is complete.
• Click the button in the upper right corner of the software screen.
• Close all other open boxes.
• Confirm all messages.
If there are additional handhelds to update via the same Network Downloader address:
• Click Close.
• Click Update.
• Repeat steps 1.12 through 1.15.
If there are additional handhelds to update via a different Network Downloader address:
• Click Close.
• Repeat steps 1.11 through 1.15.
If your facility uses Central Data Station:
• Proceed to and perform step 2.9.
4
i-STAT 1 Handheld is complete.
Art: 731336-01B
:
Rev. Date: 13-Aug-13