Abbott i-STAT 1 System Manual page 66

After completion, the following screen will be displayed.
17. If additional DRCs require configuration, connect the next DRC to the PC per step 2 and apply
power to the DRC and repeat steps 9 through 16. Otherwise, proceed to step 18.
RESTORING THE PC'S NETWORK CONFIGURATION:
18. Windows 7: Disconnect the Ethernet cable from the DRC and connect to the network. On
the PC, click Start
work and Sharing Center
Windows XP: Disconnect the Ethernet cable from the DRC and the PC. On the PC, click
Start → Settings
work Connections.
Right click on "Local Area Connection" and select Properties.
19.
20. Select the "Internet Protocol (TCP/IP)" connection and click the Properties button.
21. Restore Internet Protocol (TCP/IP) properties in the General tab to the network settings recorded
in Step 6.
22. Windows 7: Check the additional internet protocol(s) previously unchecked in Step 5.
Windows XP: Click OK and close all Control Panel windows.
23. Windows 7: Proceed to Step 24.
Windows XP: Connect the network cable from the PC to the network (wall).
24. To connect the configured DRC for transmission to the Data Manager, follow the instructions in
the Wiring the Downloader/Recharger sections below.
12
→ Control Panel → Network and Internet (if shown, skip if not)
→ View network status and tasks.
→ Control Panel → Network and Internet Connections (if listed)
Art: 728690-01F
→ Net-
→ Net-
Rev. Date: 14-Mar-14