NEC UNIVERGE UM8000 User Manual page 461

System > Switch > Cut
Field
-
Enable cut through
paging
-
Cut through page ID
-
Cut through page type
Dial out to paging
service on same port
that handled call.
-
Cut through page
initiate sequence
-
Cut through page recall
sequence
Page Field Descriptions
through Paging
-
Description
-
Select to enable cut through paging.
-
The system ID for cut through paging. This system ID is
-
used with one key dialing. For example, $CUT.
There are three types of cut
• Attended. After placing the caller on hold, the
messaging system dials the subscriber's pager and sends
the phone number. The system then reports whether this
call was successful before closing the call.
• Release. The messaging system transfers the caller to
the subscriber's paging service and ends the call.
• Unattended. The messaging system sends the caller's
phone number to the subscriber's pager and ends the call
without confirming whether the call was successful.
Select to have the system use only one port for cut
paging. Clear the box to use two ports.
The transfer sequence used to transfer the call for
-
cut through paging.
Keep this field blank to use the call transfer initiate sequence
set on the Dialing Codes page. See
Codes."
The recall sequence for cut
blank to use the call transfer recall sequence set on the
Dialing Codes page. See "Configuring Dialing
-
through paging:
-
through
"Configuring Dialing
-
through paging. Keep this field
Codes."
461