NEC UNIVERGE UM8000 User Manual page 308

Configuring the Local Site
Use this page to configure the local site before subscribers can exchange messages with subscribers in remote sites.
To configure the local site
In the Navigation Pane, click Network > Local Site Setup.
1.
For detailed field information, see the
If the Network site type is Open. The systems exchange messages using a public phone network. Configure the
2.
Open site type, otherwise skip this step:
In the Country code field, type the country code for the local system. If you do not know your country code,
a.
consult your local phone service provider. The country code can be up to five digits.
In the Area code field, type the three-digit area code for the local system.
b.
In the Phone number field, type the seven-digit phone number for the local system. Do not use hyphens or
c.
other special characters.
If the Network site type is Other carrier (Private). The system exchange messages over a private phone network.
3.
Configure the Other Carrier site type, otherwise skip this step:
• In the Private ID field, type the private ID for the local system.
Set Accept incoming network calls to Yes to allow remote subscribers to send messages to subscribers on the
4.
local system.
Set Allow outgoing network calls to Yes to allow local subscribers to send messages to remote systems.
5.
Click Save.
6.
Related Topics
Message Networking Configuration
®
UNIVERGE UM8000 Message Networking
About Networking Protocols
Adding a New Remote Site
Understanding Directories
®
UNIVERGE UM8000 Message Networking
Network > Local Site Setup table.
308