NEC UNIVERGE UM8000 User Manual page 213

Configuring Dialing Codes
Use the Dialing Codes page to set the outdial access number and the call transfer sequences for the messaging system.
Using an Outdial Access Number
Subscribers must dial an outdial access number (for example: 9) to place an external call. To enable the messaging
system to deliver messages to an outside phone number or to activate pagers, an outdial access number must be
defined. Since some phone systems require a brief pause after the outdial access number, type a comma after the
outdial access number.
When an outdial access number is defined the messaging system automatically dials the outdial access number before
dialing any message delivery number that is greater than the specified
To configure dialing codes
In the Navigation Pane, click System > Switch > Dialing Codes.
1.
For detailed field information, see the
Type the outdial access code for the phone system in the Outdial access code field. For example, type
2.
comma).
The comma provides a pause in the dialing sequence to allow time to receive the dial tone.
Type the outdial access code for return calls in the Return call outdial access code field. For example, type
3.
(nine comma).
Click Save.
4.
Changing Call Transfer Sequences
The Call Transfer Sequence fields are installed with default values. Carefully read the information in this topic, call
Technical Support or refer to the Integration Guide or phone system documentation for additional information before
changing any of the values in this section of the Dialing Codes page.
To configure call transfer sequences
In the Navigation Pane, click System > Switch > Dialing Codes.
1.
WARNING!
D
O NOT CHANGE VALUES ON THE
QUALIFIED PHONE SYSTEM TECHNICIAN
Type the appropriate sequences in the following fields. If a field does not require a value, leave it blank.
2.
• Initiate sequence. The dialing code to put a caller on hold before dialing an extension to transfer the caller.
• Connect sequence. The dialing code to complete the transfer when the called party answers or to release the
call to the destination number.
• Recall sequence. The dialing code to return to the caller when the internal extension is busy or does not
answer.
• Busy recall sequence. The sequence that represents the dialing code to return to the unidentified caller
when the internal extension is busy.
Click Save.
3.
Related Topics
Configuring Integration Options
Selecting a Phone System
Phone System Overview
Special Dialing Characters
Phone System Overview
System > Switch > Dialing Codes
S > S > D
YSTEM WITCH IALING
.
outdial trigger length
table.
C
ODES PAGE ONLY WITH GUIDANCE FROM
(OTL).
9, (nine
9,
T S
ECHNICAL UPPORT OR A
213