NEC UNIVERGE UM8000 User Manual page 219

Controlling Message Waiting Indication
Use the System > Switch > MWI page to configure message waiting indication (MWI). The phone system must have
message waiting indicators on the extensions and allow the indicators to be turned on and off from a standard
nondigital phone.
Use the To immediately reset message waiting indicators
To confirm or change message waiting indicator settings
In the Navigation Pane, click System > Switch > MWI.
1.
For detailed field information, see the
Confirm that Enable Message Waiting Indication (MWI) is selected.
2.
Confirm that the values in the Message Waiting Indicator Codes section are correct for the phone system.
3.
The messaging system must be configured using the correct codes to activate and deactivate message waiting
indication.
Confirm that the setting in the Maximum number of retries field is correct.
4.
The messaging system must be programmed with how many times to dial each message waiting code to confirm
that it takes effect.
Confirm that the value in the Wait ... minutes between retries field is correct.
5.
The messaging system waits the specified amount of time between dialout attempts to the same message waiting
indicator.
Click Save.
6.
To control message waiting indicators
In the Navigation Pane, click System > Switch > MWI.
1.
Type the reset time in the Reset MWIs daily at field if the phone system requires a daily message waiting lamp
2.
reset.
Select Reset MWI after each new message to have the messaging system immediately reset the phone
3.
message waiting indicator after each new message.
Click Save.
4.
To immediately reset message waiting indicators
In the Navigation Pane, click System > Switch > MWI.
1.
Select Reset all lamps to reset all MWI lamps.
2.
Click Save.
3.
Related Topics
Phone System Overview
Phone System Overview
to immediately reset message waiting indicators.
System > Switch > Message Waiting Indication table.
219