NEC UNIVERGE UM8000 User Manual page 220

Configuring Voice Detection
Voice detection controls the length of time the messaging system waits for a caller to speak when leaving a message,
responding to voice detect boxes, or responding to boxes with voice detect call holding.
When a caller does not speak within the specified time in voice detect boxes, the messaging system routes the caller to
the system ID specified if the caller remains silent. This is configured on the Call Management > Voice Detect Boxes >
Voice page. If a system ID is not specified for routing, the system takes the action set on the Voice Detect Boxes >
Greetings page. This same rule applies to all voice detect call holding boxes.
To change the voice detection setting
In the Navigation Pane, click System > Switch > Call Holding.
1.
For detailed field information, see the
Type the length of time, in seconds, that the messaging system waits for a caller to speak in the Maximum time
2.
the system waits for a caller to speak field.
This applies to voice detect boxes and boxes that use voice detect call holding.
Click Save.
3.
Related Topics
Configuring the Call Holding Message Cycle
Limiting the Number of Ports On Hold
Phone System Overview
Phone System Overview
System > Switch > Call Holding table.
220