Tonal Signals; Operating The Tone Key - Ricoh 170 / 180 Operator's Manual

Tonal Signals

On this model the
E
organizations offer you a special service by telephone, which you can access by
transmitting Touch Tone or DTMF tones. If your phone service provides only
pulse dialing, or if you are calling over a digital network, the ability to generate
Tonal Signals will allow you to access these services. First, dial the other party.
When you are through to the other end, press the Tone key and enter the code
number that is needed to access the required feature on the other terminal.You do
not need to press the Tone key if your machine is set up for dialing in Tone Dial
(DTMF) mode.

Operating the Tone Key

1. Make sure that the machine is in standby mode, and that there is no
document in the feeder.
2. Pick up the telephone handset, or press the On Hook Dial key.
3. Dial the remote facility. Do not press the Start key.
4. After your line is connected to the remote facility, do the following:
If your telephone Line type is DTMF (Tone Dial): Go to step 5.
If your telephone line type is Pulse Dial: Press the
pad. A dot appears on the display.
5. Input the digits that you need to use the remote facility. These digits will
depend on the remote facility.
NOTE: Do not press the Start key.
6. After you have finished your business with the remote facility, hang up.
Cross-reference
Tone Dial (Telephone Line Type): see page 21.
key on the ten keypad is used as the Tone Key. Some
TRANSMISSION
key on the ten key-
E
61