Printing The Sender's Identification; Tonal Signals - Ricoh MV310E Operator's Manual

Printing the Sender's Identification OTHER FEATURES
Printing the Sender's Identification
This feature prints at the top of the message, the sender's identification (the
CSI or RTI, see page 159) that appears on the display. This is useful if you
receive messages that don't include identification at the header. Follow the
user parameter procedure on page 121 to enter the following setting.
Switch 02, bit 3
0: Don't print the identification code
1: Print the identification code
Tonal Signals
If your machine is set for a pulse line, it will generate pulses rather than tones.
This feature allows you to generate tones from the keypad when your machine
is set for pulse dialing. Before you can use this feature, you must program
Quick Dial 19 as the tone key (see below). If your machine is already set for
touch tone dialing, you do not need this feature at all.)
To use the feature, dial the other party, then after you are connected, press the
tone key (Quick Dial 19) and dial numbers as needed. Once done, hang up.
If You Have the Optional Handset or Your Own Touch Tone Phone
This will let you to keep Quick Dial 19 for storing a fax number. If you do this,
don't forget to switch the handset back after you're done.
Setting Quick Dial 19 as the Tone Key.
Press Function, 3, 1, and Yes.
Q
Press Quick Dial 19.
0
1
Press Yes again. Quick dial 19 can now be used as the Tone key.
61