Comtech EF Data CDM-625A Installation And Operation Manual page 188

CDM-625A Advanced Satellite Modem
Front Panel Operation
CONFIG: IP  IP Setup: VLAN  PortMode  Port#
Where # denotes the selected Port:
Port #: Port Mode= Trunk
◄ ►
Use the arrow keys to select the operation parameter. Then, use the
select Trunk or Access:
•
When you select Trunk as the Port Mode, VLAN ID (PVID) does not apply. On the bottom
line of the display, the selected port's PVID will display as
• Otherwise, when you select Access as the Port Mode you must configure the VLAN IDs
(PVIDs). Edit the PVID by using the
arrow keys to change that digit, and then press ENTER. You may create a PVID in the range
from 0001 to 4095. The default is 0001.
Hold down the ▲ ▼ arrow keys to quickly scroll between 0001 and 4095.
CONFIG: IP  IP Setup: VLAN  VLAN-Table
VLAN Table:
View/Edit/Delete
The VLAN table supports up to 32 entries. Use the
Add-Entry. Press ENTER.
CONFIG: IP  IP Setup: VLAN  VLAN-Table  View / Edit / Delete
VLAN ID:0001 P1:Filtered
P3:Tagged
Do these steps to view, edit, or delete existing VLAN IDs:
• First, use the
o VLAN ID – Selects the tabulated VLAN ID. After selecting VLAN ID, use the
keys to scroll through the available VLAN IDs.
o ACT – Choose an action to undertake for the selected VLAN ID – NONE (default), Edit, or
Del (Delete).
o P1 (Port1) through P4 (Port4) – With ACT=Edit active, you may update the selected
port's behavior attributes, as assigned under the selected VLAN ID.
PVID=N/A
◄ ►
P4:Untagged
◄ ►
arrow keys to select the desired parameter:
PVID=N/A
arrow keys to select a digit. Then, use the
Add-Entry
◄ ► arrow keys to select View/Edit/Delete or
P2:Untagged
ACT=None(N,E,D)
6–64
MN-CDM625A
Revision 4
()
arrow keys to
▲▼
.
▲▼
()
arrow
▲▼