Table of Contents
Advertisement
CDM-625A Advanced Satellite Modem
Appendix K
K.4.1.1
Router Multipoint Hub Configuration
To configure a Router Multipoint Hub Network:
•
For the "Hub Outbound" Modem Configuration:
o Referring to Sect. 7.5.4.3.2.1 Configuration | LAN | IP in Chapter 7. ETHERNET-BASED
PRODUCT MANAGEMENT: From the page's Network Configuration section, use the
Working Mode drop-down menu to select the mode as Router Multipoint Hub, and
then click [Submit] to accept this configuration change.
o Referring to Sect. 7.5.4.3.3.1 Configuration | Routing | Routes in Chapter 7. ETHERNET-
BASED PRODUCT MANAGEMENT: From the page's Add New Route section, add a route
entry for each remote subset. Make sure to select toWAN from the Interf. drop-down
menu (this defines the route as LAN WAN).
Click [Add Entry] once each route is created.
•
For the "Hub Demod" Modem Configurations:
o Referring to Sect. 7.5.4.3.2.1 Configuration | LAN | IP in Chapter 7. ETHERNET-BASED
PRODUCT MANAGEMENT: From the page's Network Configuration section, use the
Working Mode drop-down menu to select the mode as Router Multipoint Hub, and
then click [Submit] to accept this configuration change.
o Referring to Sect. 7.5.4.3.3.1 Configuration | Routing | Routes in Chapter 7. ETHERNET-
BASED PRODUCT MANAGEMENT: From the page's Add New Route section, add a route
for each remote subset. First, make sure to select toLAN from the Interf. drop-down
menu (this defines the route as WAN LAN); then, when assigning the Next Hop IP
address, make sure it is identical to the Hub Outbound modem's IP address.
Click [Add Entry] once each route is created.
•
For the "Remote" Modem Configurations:
o Referring to Sect. 7.5.4.3.2.1 Configuration | LAN | IP in Chapter 7. ETHERNET-BASED
PRODUCT MANAGEMENT: From the Network Configuration section, use the Working
Mode drop-down menu to select the mode as Router Multipoint Remote, and then
click [Submit] to accept this configuration change.
o Referring to Sect. 7.5.4.3.3.1 Configuration | Routing | Routes in Chapter 7. ETHERNET-
BASED PRODUCT MANAGEMENT: Add a default LAN route entry using the page's Add
New Route section. First, specify the Hub Outbound modem's IP address as the gateway
address, and then select toWAN from the Interf. drop-down menu (this defines the
route as LAN WAN).
Click [Add Entry] once the route is created.
K–10
MN-CDM625A
Revision 4
Advertisement
Chapters
Table of Contents
