Config: Misc  Hirateesc - Comtech EF Data CDM-625A Installation And Operation Manual

CDM-625A Advanced Satellite Modem
Front Panel Operation
6.2.1.10.6 CONFIG: Misc  HiRateESC
High-Rate-ESC=Off (Off,On)
2400 baud
The ESC (Engineering Service Channel) is determined by the framing type (IBS, D&I, or ESC++)
selected under CONFIG: Mode. The High Rate IBS (Engineering Service Channel) requires the
Open Network FAST option. Both Tx and Rx Framing must be configured as IBS or D&I for this
feature to be enabled. When enabled, the lower of the Tx or Rx primary data rate limits the
maximum baud rate as follows:
Data Rate
64 kbps
≥ 128 kbps
≥ 256 kbps
≥ 384 kbps
≥ 512 kbps
≥ 768 kbps
≥ 1024 kbps
Appendix P. OPEN NETWORK OPERATIONS
ESC++ is available as standard. Both Tx and Rx framing must be set to ESC++. When you enable
ESC++, the lower of the Tx or Rx primary data rate limits the maximum baud rate as follows:
Data Rate
≥ 64 kbps
≥ 128 kbps
≥ 192 kbps
≥ 256 kbps
≥ 384 kbps
≥ 512 kbps
Appendix J. ESC++
Use the ◄ ► arrow keys to select a parameter to edit. Then, use the
setting, and press ENTER. Valid selections are:
•
High-Rate-Esc operation: Off or ON.
•
RS-232 or RS-485.
• Baud rate (range depends on other configuration parameters, previously noted).
• Character format (number of data bits, parity, number of stop bits): 8N1 (8-None-1), 7E2
(7-Even-2) or 7O2 (7-Odd-2).
DataParityStop=8N1
Max ESC Baud Rate
2400
4800
9600
14400
19200
28800
38400
Max ESC++ Baud Rate
4800
9600
14400
19200
28800
38400
RS-232
6–47
MN-CDM625A
Revision 4
()
arrow keys to select its
▲▼