Use The Modem Configuration File To Configure A Target Modem - Comtech EF Data CDM-625A Installation And Operation Manual

CDM-625A Advanced Satellite Modem
Appendix U
226 Transfer complete
ftp: XXXX bytes received in X.XXSeconds XXXXXXX.XXKbytes/sec.
ftp>
•
Type "bye" without quotes at the Command-line ftp> prompt to terminate the FTP
session, and then close the Command-line window.
U.2.2

Use the Modem Configuration File to Configure a Target Modem

1) OPTIONAL –
to save, upon execution of the FTP "put" command (see Step 3), the configuration
parameters of this file to a specified modem configuration slot (as you would by using the
CDM-625A Front Panel SELECT: Store/Ld ►Store screen).
•
Make sure that you are in the folder containing the Modem Configuration File
(config_file) created in Sect. U.2.1.
•
Use a text editor such as Windows Notepad to open the Modem Configuration File
(config_file).
•
Add, as the first line in the configuration file, "SAVE MGC TO SLOT #" without quotes
(where # is modem configuration slot 0 through 9), as per this example...
• Save and close the Modem Configuration File. Continue to the next step.
2) Use Command-line to send a "PING" command to confirm proper connection and
communication between the User PC and the CDM-625A Target Modem:
•
Open a Command-line window...
For Windows 95 or Windows 98, type "command".
For any Windows OS versions later than Windows 98, type "cmd" or "command".
Alternately, from [Start], select All Programs > Accessories > Command Prompt.
You may optionally edit the Modem Configuration File to instruct the modem
►
SAVE MGC TO SLOT 6
MGC=0070.000...etc.
OGC=010x00xxx...etc.
DNI=100000000...etc.
etc...
This text string is case-sensitive. Be sure to specify an "Available"
configuration slot.
U–3
MN-CDM625A
Revision 4