Removing The Front Usb Assembly - Lenovo HX3510-G Installation And Service Manual

Handle
Figure 50. Power paddle module installation
Step 5. Replacing the power supplies (See "Replacing a hot-swap ac power supply" on page 181).
Step 6. Replacing the top cover (see "Replacing the top cover" on page 118).
Step 7. Slide the server into the rack.
Step 8. Reconnect the power cords and all external cables, and turn on the server and peripheral devices.

Removing the front USB assembly

Use this information to remove the front USB assembly.
Note: The front USB assembly is available only on some models.
To remove the front USB assembly, complete the following steps.
Step 1. Read the safety information that begins on "Safety" on page v and "Removing and replacing
guidelines" on page 101.
Step 2. Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3. Remove the top cover (see "Removing the top cover" on page 116).
Step 4. Disconnect the cable on the front USB assembly from the system board.
Step 5. 1 Pull up the release latch slightly and
Power paddle assembly
2 slide the front USB assembly out of the server.
.
Chapter 5 Removing, and replacing components
123