Table of Contents
Advertisement
Figure 51. Front USB assembly removal
Step 6.
If you are instructed to return the front USB assembly, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Replacing the front USB assembly
Use this information to replace the front USB assembly.
Note: The front USB assembly is available only on some models.
To install the front USB assembly, complete the following steps.
Step 1.
Read the safety information that begins on "Safety" on page v and "Removing and replacing
guidelines" on page 101.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3.
Remove the top cover (see "Removing the top cover" on page 116).
Step 4.
Align and slide the front USB assembly into the server until it clicks into place.
Figure 52. Front USB assembly installation
Step 5.
Connect the cable on the front USB assembly to the system board.
124
HX3510-G, HX5510, HX5510-C, HX7510 Installation and Service Guide
1
2
Front USB assembly
Release latch
Front USB assembly
- Quick Links:
- Replacing a Memory DIMM
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
