Lenovo HX3510-G Installation And Service Manual page 32

Figure 15. Rear view: HX7510 models
• Power connector: Connect the power cord to this connector.
Note: Power supply 1 is the default/primary power supply. If power supply 1 fails, you must replace it
immediately.
• Video connector: Connect a monitor to this connector.
Note: The maximum video resolution is 1600 x 1200 at 75 Hz.
• Two USB 3.0 connectors : Connect a USB device, such as a USB mouse or keyboard to any of these
connectors.
• Systems-management Ethernet connector: Use this connector to connect the server to a network for
full systems-management information control. This connector is used only by the IMM2.1. A dedicated
management network provides additional security by physically separating the management network
traffic from the production network. You can use the Setup Utility to configure the server to use a
dedicated systems management network or a shared network. See Using the Setup Utility in the Problem
Determination and Service Guide for more information.
• Ethernet connectors: Use either of these connectors to connect the server to a network. When you
enable shared Ethernet for IMM2.1 in the Setup Utility, you can access the IMM2.1 using either the
Ethernet 1 or the system-management Ethernet (default) connector. See Using the Setup Utility for
more information.
The following illustration shows the LEDs on the rear of the server.
20
HX3510-G, HX5510, HX5510-C, HX7510 Installation and Service Guide